Shipping Container Maintenance – Don’t Weld It, Patch It – AN INSTANT Patch Hardens in Sunlight

I have sold shipping and delivery containers for a number of years and I promote them because I love them. I like the recycling aspect, I love the subsidised cost of these – subsidised due to huge number of containers desired in the shipping and delivery industry. And I like the modern type of the symmetrical cube, a container home could be a thing of beauty but…

There are a few serious issues to overcome if you are going to work with a seacan for any of many practical makes use of. Yes a container provides quick low cost storage. A shipping container could be easily modified as an office, workshop or cabin. Taken up to their limits they’re used as exhibition centres, accommodations not to mention homes. As long as they are primed, painted, sealed and elevated you can hold back the rust. But that is clearly a lot of effort if you purchased a rusty aged seacan and need some easy non-insulated storage. Usually vehicle, supplies or equipment storage.

So back many years ago you often painted it or acquired a welder atlanta divorce attorneys season or two. ลวดเชื่อมเงิน There are straightforward fibreglass pliable reinforced polyester patches that harden in uv light and are prepared to sand, tap, drill or color within an hour. Yes that is just sunlight! The patches will bond to rusty floors, patches are waterproof and resistant to serious temperatures, extreme heat and cool.

If your dealing with UV Quick patches within, UV light may be an issue but UV flashlights are available for around $20 available in hardware retailers. Although for shipping container maintenance you’re probably working on the exterior of the seacan anyway.

Identifying a leak in a container can be in my experience as simple as going in the container in the brightness of moment, closing the doors and looking for light. Once a hole is identified, identify it on the outside of the can and take away the pliable patch from the silver foil and utilize over the hole. You can reduce and mould the patch to condition. Bond the patch to the steel with pressure. Keep applying pressure over the entire section of the patch for one minute or 2 and your done. I take advantage of my thumbs to press down on the patch. Applying the patch is best done on a clean dry area so take a cloth with you. A wire brush if you some surface rust or a grinder with a cable brush attachment for much more serious rust issues.

The patch will be rock hard in half one hour on a cloudy day. quarter-hour on a sunshiney day. You have about 3 minutes to put your patch from beginning the foil package. After an hour you can sand and paint the patch. Or drill a hole and hang a shelf. It really is a solid bond.

I have now repaired a dozen or so shipping containers using this method over the last six months and today the rain and snow have arrived my container inspections have proven that this product really does work well.

Leave a comment

Your email address will not be published. Required fields are marked *